• Lift the pot grids one by one with both hands (be
careful not to scratch the base).
• Remove the burner head cover, the burner ring
and the burner head.
• Important! Only clean the burner parts when
cold!
• Important! Do not remove the rear covers of the
air intake (see picture)!
• Soak burnt-in remainders in a little water and
detergent. This loosens even the most stubborn of
soiling. Do not use any abrasive agents and
abrasive sponges.
• Only use very little water to clean your cooktop.
Be careful that no water enters the burner base.
• As the result of heat development, slight dis-
coloration can appear on the stainless steel
surface. Do not attempt to scrape away such
discoloration. This damages the surface.
Distribute stainless steel care agents uniformly
and thinly on the hob. This will ensure an even
surface and will keep your hob in a good
condition for a long period of time.
• Always keep the electrodes clean. Remove burnt-
in residues. Clean the elctrodes carefully with the
enclosed brush. Do not twist or damage the
electrodes.
• Always keep the air channel in the burner ring
clean (large burner only). If required clean air
channel with the included tool (see picture).
$ Caution, risk of injury! The tool has sharp
edges.
• Make sure the burner parts are dry before
assembly.
• When assembling the burner parts, make sure
that the burner ring and burner head are placed in
such a way that the locking lugs fit in the
corresponding recesses.
13
