755787
17
Zoom out
Zoom in
Previous page
1/56
Next page
16
en Operating the appliance
Inserting accessories
The wire rack and the perforated cooking container are
fitted with a locking function. The locking function
prevents the accessories from tilting when they are
pulled out. The accessories must be correctly inserted
into the cooking compartment for the tilt protection to
work properly. To pull out the accessories, lift them
slightly.
When inserting the wire rack, make sure that
the lug (a) is facing downwards
the safety bar on the wire rack is at the back and
facing upwards.
When inserting the cooking container, ensure that the
lug (a) is facing upwards.
Switching on
1Use the function selector to set the required type of
heating. The selected type of heating and
recommended temperature appear on the display.
2If you wish to change the temperature:
Turn the rotary selector to set the desired
temperature.
The heat-up symbol appears on the display. The bar
shows the current heat-up status. When the set
temperature has been reached, an audible signal
sounds and the heat-up symbol goes out.
Note: The temperature that has been set will be
retained when you change to a different operating
mode. The suggested temperature does not appear until
the appliance has been switched on.
Switching off
Turn the function selector to 0.
Depending on the operating mode, you may hear an
automatic rinse cycle running.
Steam injection
With steam injection, steam is specifically injected into
the cooking compartment. This enables you to bake, e.g.
bread and bread rolls, with sufficient moisture.
Steam injection only works with these types of heating:
Hot air + 30% humidity
Hot air + 0% humidity
Full surface grill + air recirculation
To start steam injection, touch the ð symbol. After a
short while, steam is injected into the cooking
compartment.
Steam is injected for approx. 5minutes.
To cancel steam injection:
Press the ñ symbol.
Steam removal
During the steam removal process, cold water is
introduced into the cooking compartment. This cools
the cooking compartment down and the steam
condenses on the cooking compartment wall. When you
then open the cooking compartment door, only a little
steam escapes.
mWarning – Risk of scalding!
After opening the cooking compartment door, hot water
may drip down from it.
Steam removal only works with the following types of
heating and if the temperature in the cooking
compartment is below 130 °C:
Hot air + 100% humidity
Hot air + 80% humidity
Hot air + 60% humidity
Full surface grill Level 1+ humidity
Full surface grill Level 2+ humidity
Sous-vide cooking
Proceed as follows:
Touch the ¡ symbol. Steam removal takes
approximately 25seconds. During this time, the heating
is switched off.
Stopping steam removal early:
Open the door or touch the ¢ symbol.
D
D
D
D
17
Time-setting options en
Notes
The steam removal function is also available for a
short time after switching off the appliance.
Steam removal takes place automatically at the end
of an automatic programme or a timer programme
(cooking time).
After every use
1Remove food remnants from the cooking
compartment surfaces as soon as the appliance has
cooled down. Burnt-on remnants will be much
harder to remove later.
2In order to dry the cooking compartment, the
cooling fan and the fan wheel on the back wall of
the cooking compartment continue to run for a
while after the appliance is switched off. They then
switch off automatically. This may take up to
95 minutes. The appliance door must remain closed
while the cooking compartment is being dried.
3If required, you can dry the cooking compartment
quickly using the drying programme. ~ "Drying
programme" on page 36
4Once the cooking compartment has cooled down,
polish it with a soft cloth.
5Wipe units and handles dry where condensation
has formed.
Safety shut-off
For your protection, the appliance is equipped with an
automatic safety shut-off. Any heating process is
switched off after 12 hours if the oven is not operated in
this time. A message appears in the display.
Exception:
The long-term timer has been programmed.
Set the function selector to 0, then the appliance can be
operated again as usual.
O
Time-setting options
Time-sett ing options
You use the timer menu to make the following settings:
Š Short-term timer
p Stopwatch
6 Cooking time (not in standby mode)
5 Cooking time end (not in standby mode)
Calling up the timer menu
You can call up the timer menu from any mode. Only
from the basic settings, function selector is set to S, the
timer menu is not available.
Touch the M symbol.
The timer menu is displayed.
Timer
The timer runs independently of the other appliance
functions. You can enter a maximum of 90 minutes.
Setting the timer
1Call up timer menu.
The "Timer" Š function is displayed.
2Turn the rotary selector to set the required cooking
time.
3Start with I.
6KRUWWHUPWLPHU

17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gaggenau BSP270111 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gaggenau BSP270111 in the language / languages: English as an attachment in your email.

The manual is 3,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gaggenau BSP270111

Gaggenau BSP270111 User Manual - German - 56 pages

Gaggenau BSP270111 User Manual - Dutch - 64 pages

Gaggenau BSP270111 User Manual - French - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info