755835
27
Zoom out
Zoom in
Previous page
1/40
Next page
26
en Cleaning and maintenance
6Place the descaling tablet in the compartment at
the back of the tank. Fill the tank with water up to
the "Max." mark (1.7 litres).
7Position the lid on the tank and click it into place.
8Slide the tank into the appliance.
9Close the appliance door. Press to confirm. A
descaling time of 1 hour 50 minutes is displayed.
10 Press I to start. The descaling time will count down
on the display. The light in the cooking
compartment remains switched off.
Note: After approximately 1:30 hours, a message
appears in the display. Remove and drain the tank.
Clean the tank thoroughly. Fill the tank with fresh
water. Slide the tank into the appliance. Confirm by
pressing . Press I to start the rinsing process.
11 Once the descaling programme has ended, an
audible signal sounds. A message appears in the
display.
Wipe the cooking compartment dry with a soft cloth.
Cleaning the tank
Descaler residues are left in the tank after descaling.
You must therefore clean the tank once the descaling
program has ended.
1Remove the tank from the appliance and take off
the lid.
2Clean the tank and lid in the dishwasher.
Removing the wire racks
The wire racks can be removed for cleaning.
Removing the wire racks
1Place a dishcloth in the cooking compartment to
protect the enamel from scratches.
2Lift the wire racks slightly at the front (Fig. A) and
pull them out sideways towards the front (Fig. B).
You can clean the wire racks in the dishwasher.
Refitting the wire racks
1Attach the wire racks the right way round – with the
end stop at the back.
2Slide the back of wire racks onto the bolts, then
reattach them at the front.
O
0D[
0D[
/

$%
27
Trouble shooting en
3
Trouble shooting
Trouble shooti ng
Malfunctions often have simple explanations. Please
read the following notes before calling the after-sales
service.
mWarning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by one
of our trained after-sales technicians. If the appliance is
defective, unplug the appliance from the mains or switch
off the circuit breaker in the fuse box. Contact the after-
sales service.
mWarning – Risk of injury!
The light emitted by LED lights is very dazzling, and can
damage the eyes (risk group 1). Do not look directly into
the switched on LED lights for longer than 100seconds.
LED lights
Defective LED lights must only be replaced by the
manufacturer, their customer service department or a
licensed technician (electrician).
Disruption Possible cause Solution
Appliance not working, no display Plug not inserted Connect the appliance to the electricity
mains
Power failure Check whether other kitchen appliances
are working
Fuse defective Check in the fuse box whether the fuse
for the appliance is in working order
Operating error Switch off the fuse for the appliance in
the fuse box and switch it on again after
about 60seconds
The appliance does not work, the dis-
play shows "Device locked. Descaling
required."
Build-up of limescale in the appliance Start the descaling programme
~ "Descaling programme"
on page 25
Despite descaling, "Please descale"
appears on the display
Build-up of limescale in the appliance,
wrong descaler used
Use the specified descaling tablets,
start the descaling programme
~ "Descaling programme"
on page 25
Appliance cannot be started Appliance door is not quite closed Close appliance door
The appliance does not work, the dis-
play shows "E182"
No water available in the appliance Take out the water tank and verify that
the suction pipe in the tank is straight,
not kinked. Please contact the after-
sales service if the error message per-
sists.
The appliance is not working and the
display does not respond. 0 appears
on the display
Childproof lock activated Deactivating the childproof lock
~ "Childproof lock" on page 18
Appliance switches off on its own Safety shut-off: the appliance has not
been operated for longer than 12hours
Confirm the message with , switch off
the appliance and set it again.
Appliance does not heat up, ° appears
in the display
Appliance is in demo mode Deactivate the demo mode in the basic
settings
The appliance cannot be started, the
display shows an error message
The water tank is empty Fill the water tank
Powerful steam outlet at the top of the
door
The operating mode has been changed This is normal
A lot of steam escapes at the side of the
door
Door seal soiled or loose Clean the door seal and insert it in the
groove
A whistling noise occurs during heating Noises may occur during steam genera-
tion
This is normal
There is a "pop" noise during cooking Cold/warm effect with frozen food,
caused by the steam
This is normal
Steaming is not possible Build-up of limescale in the appliance.
Appliance must be descaled to avoid
damage to the appliance
Starting the descaling
program~ "Descaling programme"
on page 25
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gaggenau BSP220111 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gaggenau BSP220111 in the language / languages: English as an attachment in your email.

The manual is 2,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gaggenau BSP220111

Gaggenau BSP220111 User Manual - German - 40 pages

Gaggenau BSP220111 User Manual - Dutch - 44 pages

Gaggenau BSP220111 User Manual - French - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info