14
en Before using for the first time
K
Before using for the first time
Before using for the f i rst time
In this section, you can find out what you must do
before using your appliance to prepare food for the first
time. First read the section entitled ~ "Important
safety information" on page 5.
The appliance must be fully installed and connected to
the mains.
After connecting the appliance to the power supply, the
"Initial settings "menu will be displayed. Now you can
now configure your new appliance for initial set-up.
Notes
– The "Initial settings" menu will appear only after the
appliance has been connected to a power supply
and switched on for the first time, or if the
appliance has not been connected to a power
supply for a number of days.
Once the appliance has been connected to a power
supply, the GAGGENAU logo will appear first for
approximately 30seconds. The "Initial settings"
menu will then appear automatically.
– You can change the settings at any time in the basic
settings.
Setting the language
The preset language appears in the display.
1Turn the rotary selector to select the required
display language.
2Confirm with ™.
Setting the time format
The two possible formats 24h and AM/PM appear in the
display. The default is the 24h format.
1Use the rotary selector to select the desired format.
2Confirm with ™.
Setting the clock
The time is shown in the display.
1Set the desired time using the rotary selector.
2Confirm with ™.
Setting the date format
The three possible formats D.M.Y, D/M/Y and M/D/Y
appear in the display. The default is the D.M.Y format.
1Use the rotary selector to select the desired format.
2Confirm with ™.
Setting the date
The preset date appears in the display. The day setting
is already active.
1Set the day using the rotary selector.
2Touch the C symbol to switch to the month setting.
3Set the month using the rotary selector.
4Touch the C symbol to switch to the year setting.
5Set the year using the rotary selector.
6Confirm with ™.
Setting the temperature unit
The two possible units °C and °F will appear on the
display. The default unit is °C.
1Use the rotary selector to select the unit you
require.
2Confirm with ™.
Setting the water hardness
"Water hardness" appears in the display.
1Check the mains water with the included carbonate
hardness test: fill the small measurement tube with
mains water up to the 5 ml mark.
2Add drops of indicator solution until the color
changes from purple to yellow.
Important: count the drops and carefully swing the
measurement tube after every drop until the liquids
have mixed thoroughly. The number of drops
corresponds to the water hardness.
3Use the rotary selector to set the measured water
hardness. The value 12is set by default.
4Confirm with ™.
Ending initial set-up
"Initial set-up complete" will appear on the display.
Confirm with ™.
The appliance will switch to standby mode and the
standby display will appear. The appliance is now ready
to use.
Cleaning the door panel
The door seal has been greased in the factory to make it
leaktight. There may be traces of grease left on the door
panel.
Clean the door panel with glass cleaner and a window
cloth or microfibre cloth before using the appliance for
the first time. Do not use glass scrapers.
cloth.
cooking compartment.
appliance with the door closed. One hour with hot air H
+ 60% humidity at 200 °C is ideal for this.
is set or the childproof lock is activated.
standby mode.
time. You can adjust the display using the "Standby
screen" setting in the basic settings.
vertical viewing angle. You can adjust the display
using the "Brightness" setting in the basic settings.
You can now set the desired function. You can read
about how to set functions in the respective chapters.
to exit standby mode.
activation.
switches off after a short time.
