29
Changing the bulbs
•
Before changing the bulbs, always follow the
instructions and warnings in the chapter
entitled ”Safety instructions”!
•
The description of changing the bulbs applies
to several appliance models.
Note:Observe the warranty regulations in the
enclosed service booklet.
Changing the halogen bulbs
ṇ RISK OF INJURY
Halogen bulbs become very hot during operation.
Even some time after the appliance has been
switched off, there is still a risk of burns!
•
Defective bulbs should be replaced immediately
to avoid overloading the remaining bulbs.
•
Before changing the halogen bulbs, ensure that
they have cooled down fully.
1 Carefully remove the bulb ring with a suitable
tool.
2 Replace the defective bulb with a new one of
the same type and equivalent power (see rating
plate).
Note:When inserting halogen bulbs, do not touch
the glass tube. Therefore use a clean cloth when
inserting the bulb.
3 Reinsert the bulb cover.
4 Restore the power supply by inserting the
mains plug or switching on the fuse.
Changing the filament bulbs
ṇ RISK OF INJURY
Filament bulbs become very hot when switched on.
Even some time after filament bulbs have been
switched off, there is still a risk of burns!
•
Before changing filament bulbs, wait until they
have completely cooled down.
1 Lift the bulb cover slightly.
2 Push the bulb cover towards the middle of the
appliance.
3 Replace the defective bulb with a new one of
the same type and equivalent power (see rating
plate).
4 Reinsert the bulb cover.
5 Restore the power supply by inserting the
mains plug or switching on the fuse.
Note:If the light does not function, check whether
the bulbs have been inserted correctly.
