Manual Fuxtec RM5196eSPRO (page 54 of 135) (English, German, French, Italian)

781727

Zoom out

Zoom in

1/135

Original User Manual FUXTEC FX-RM Series_de_en_fr_ita_rev19

Charging port

Backup

Battery Mount Model FX-RM5196eS

4. Slide the battery into the holder at the rear end of the motor

5. If necessary, charge the battery using the AC charging connector provided. This should only be

necessary if the mower has not been moved for a long time

6. If the engine does not start, check the fuse on the side of the battery

The LED lights indicate the battery's state of charge; the following notes on LED indicators should be

observed:

• LED lights up red -> state of charge low

• LED flashes red -> battery alarm: fuse defect /overheating/check plug

• LED is green -> charge status is ok

• LED flashes green -> battery is charged during operation

Battery charge level:

4 LED green 100%

3 LED green 70 ~ 100%

2 LED green 40 ~ 70%

1 LED green 10 ~ 40%

1 LED red 0 ~ 10%

25. Starting / stopping the engine

Start (except FX-RM5196eS next page)

Make sure that the engine is filled with sufficient oil and gasoline before you start it.

Pull the brake lever (upper lever) against the handle and pull the starter cable slightly until resistance is

felt. Then pull the starter cable smoothly until the engine starts. On the 4646eco model, please press the

primer pump 3-5 times before pulling the starter cable to fill the carburetor with gasoline.

NOTE:

Do not operate the wheel drive lever at the same time. Only when the engine has started, and you want to

use the self-propulsion do you operate the lower lever.

Due to a protective layer on the engine, a slight smoke may be produced when you use the device for the

first time. This is a standard procedure. Pull the brake lever towards the push handle. Do not let the pull

starter snapback.

Stop

Release the brake lever to stop the motor.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Fuxtec RM5196eSPRO in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 4.47 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Fuxtec RM5196eSPRO Manual

Product: