781721

Fuxtec RM5196 PRO Manual

61
Zoom out
Zoom in
Previous page
1/135
Next page
Original User Manual FUXTEC FX-RM Series_de_en_fr_ita_rev19
61
1. Set the cutting height lever to the most adverse position.
2. Remove the locking screws from the lower bar at
the upper fixation (exact position see picture 3, red arrow)
and store them well for the next use of your mower.
3. Open the wing screws on the lower spar.
4. Fold up the handlebar.
5. Fasten the handle with the rubber band provided.
6. Now stow your mower to save space.
29. Care, maintenance, and storage
CHANGING THE CUTTING BLADES
Remove the screw to replace the blade. Empty the fuel tank before removing the blade.
Replace everything, as shown. Fasten the screw properly. The fastening torque is 45Nm. Also, replace the
blade screw when replacing the blade.
OIL CHANGE
1. Switch off the engine and let it stop completely.
2. Disconnect the spark plug cable and keep it away from the spark plug.
3. Empty the oil into a suitable container. Tilt the lawnmower by 45 degrees and use a FUXTEC suction
pump to suck off the oil through the filler neck. Alternatively, you can tilt the mower more to drain the oil
through the filler neck.
4. Keep the engine balanced. Remove the dipstick. Slowly add approximately 0.5L of new recommended oil
(FUXTEC 4MAX 4 stroke oil) into the container until the dipstick reads the top of the container. Do not
overfill the container.
5. Check the level with the dipstick
WARNING: Avoid skin contact with
the oil. Wash your hands
thoroughly with soap and water
after changing the oil.
ATTENTION: Used oil is a
hazardous waste product. We
recommend that you take used oil
to your local disposal center for
proper disposal. Do not dispose of
the device with household waste.
… 61 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fuxtec RM5196 PRO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fuxtec RM5196 PRO in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 4.47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info