Manual Fuxtec FX-MS162 (page 49 of 118) (English, German, French, Italian)

781735

Zoom out

Zoom in

1/118

Original Bedienungsanleitung FUXTEC FX-MS152 / FX-MS162_de_en_fr_ita_rev16

NOTE: If the engine does not start after repeated attempts, please read the

troubleshooting chapter.

NOTE: Always pull the starter cord straight out. Pulling the starter at an angle will cause

the rope to rub against the eyelet. The oblique pulling can cause the starter cable to fray

or break. Always hold the starter handle firmly when the rope is pulled back. Never allow

the rope to be thrown back from the pulled-out position. This could damage the starter

device.

30. Warm start of the engine

1. Place the device on a firm and flat surface.

2. Slide the engine stop switch down.

3. Slide the choke to the "WARM START" position.

4. Pull out the starter rope with a short-stroke until resistance is felt

(about 100mm). A continuous, mainly fast pull will provide a strong spark and start the

engine.

If the engine does not start, please proceed again according to "Cold starting the

engine."

31. Stopping the device

Unlock the throttle. Let the engine return to neutral. Move the engine stop switch on the

handle upwards until it stops. If it does not stop, pull out the spark plug connector in an

emergency. Never leave the device unattended while it is running.

32. Trimming techniques

ADDITIONAL SAFETY INSTRUCTIONS

Before running your device, read notes in chapters 3 and 4 of this manual.

CAUTION

IF YOU are NOT familiar with the trimming techniques, practice with the DEVICE in the

"STOP" position (turned off).

ALWAYS TRIM OR CUT AT HIGH ENGINE SPEEDS. Never run the device slowly at the

beginning of (or during) trimming operation.

ALWAYS MAKE AWAY DISTANCE IN THE WORKING AREA from cans, bottles, rocks, etc.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Fuxtec FX-MS162 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 2.53 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Fuxtec FX-MS162 Manual

Product: