Manual Fuxtec FX-E1RT20 (page 29 of 51) (English, German, French)

781797

Zoom out

Zoom in

1/51

Original User Manual FUXTEC 20V Cordless Grass Trimmer FX-E1RT20

Installation of the protective shield and rotation disk

To attach the protective shield to the trimmer, make sure that the holes for the screws are correctly

aligned.

To do this, place the opening of the label over the head of the battery trimmer and turn it so that the

plastic rails snap into each other. As already mentioned, pay attention to the correct position of the

drill holes. Now fasten the protective shield with the 2 screws supplied.

The rotation disk can then be attached to the center of the sensor head with the supplied screw.

Settings before use

Adjust shaft length

Adjust the grass trimmer to your height. To do this, loosen the threaded sleeve on the shaft coupling

(Figure 1, item 9). Pull out the lower shaft until the ideal spar length is reached. Tighten the threaded

sleeve

Adjusting the handlebars

Adjust the handlebar to your height. To do this, press the button on both sides of the handlebar and

keep it pressed (Figure 1, item 10). Place the handlebar in the desired position. Release the button

when the desired position is reached.

Adjust head tilt

With the grass trimmer, 3 angles of head tilt can be adjusted. This allows you to easily reach

problematic and hard to reach places in the garden. The cutting head should always be parallel to the

ground. Press the locking knob (fig. 1, point 4) to set the desired working angle.

Plant hoop guard

The plant protection bar protects shrubs, trees, and bedding plants. If the plant protection bar is not

needed, it can be folded up.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Fuxtec FX-E1RT20 in the language / languages: English, German, French as an attachment in your email.

The manual is 2.74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Fuxtec FX-E1RT20 Manual

Product: