781832
29
Zoom out
Zoom in
Previous page
1/53
Next page
Original User Manual FUXTEC FX-DH116_rev03
29
Circuit diagram:
16. Troubleshooting
Fault
Cause
Measure
The engine does not start
E1 Error on the display
- No current or low voltage
- Power cable defective or
damaged
- Engine/Capacitor defect
- Device locked due to
overheating
- Check the power line and
voltage, check the fuse
- Check the power cord and
replace it
- Check the engine and
capacitor and replace it if
necessary.
- Determine the cause of
overheating
- Wait a few minutes and
restart the device
The engine runs, but the heater
does not ignite and locks after a
short time
- Empty fuel tank, dirty or
wrong fuel
- Fuel filter clogged
- Hole in the oil line
- Burner nozzle clogged
- Fuel Viscosity not good
- Remove wrong or dirty fuels
- Fill the tank with clean
diesel
- Clean or replace the fuel
filter
- Check Hoses
- Clean nozzle, blow in
compressed air
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fuxtec FX-DH116 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fuxtec FX-DH116 in the language / languages: English, German, French as an attachment in your email.

The manual is 1.68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info