781832
26
Zoom out
Zoom in
Previous page
1/53
Next page
Original User Manual FUXTEC FX-DH116_rev03
26
14. Assembly & Commissioning
Mount the device, as shown in the picture.
Start it:
Fill the tank with clean fuel. Use only diesel fuel. You can read the level in the fuel gauge
above the tank. Connect the power cord. Grounding is mandatory. Now the ambient
temperature is displayed. Slide the power switch to "ON." If the temperature control is set
so that the temperature is higher than the ambient temperature, the heater will start after
7 seconds.
If the temperature controller is set lower, the device will not start.
Cold start:
At low temperatures, keep the air vent closed with one finger to start.
If the heater locks up, you will have to do a manual restart:
Check and remove the cause of the lockout before restarting the heater. To reset, set the
On/OFF switch to 0 and then back to I. If the lockout is repeated, contact customer service.
Switch off:
Slide the switch to OFF and disconnect the device from the power supply.
Do not disconnect from the power supply during operation. Keep the device connected
during the cooling sequence. Do not cover the heater. Do not block the air inlet and outlet.
The heater cover is very hot after operation. Do not touch it! Wear protective clothing. Do
not touch the device with wet hands.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fuxtec FX-DH116 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fuxtec FX-DH116 in the language / languages: English, German, French as an attachment in your email.

The manual is 1.68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info