566460
13
Zoom out
Zoom in
Previous page
1/94
Next page
13
LINKING PROCEDURE


link is made, the ID code is stored in the receiver and no further linking is necessary unless the receiver is to
be used with another transmitter. In the case of this T6J transmitter/receiver set, the linking has already been
completed at the factory. However, it is always a good safety precaution to perform this linking procedure
once again, regardless.
     
existing transmitter. In order to do so, follow the procedure below:
1) Place the transmitter and the receiver close to one another. Generally speaking, as long as the transmitter

2) Turn on the transmitter.
3) Check the LED that is located on the face of the T6J transmitter. When the blue LED is on, and solid (no
blinking), the RF signal is being transmitted.
4) With power connected to the receiver turn on the receiver. The LED
on the face of the receiver will begin blinking.

switch on the receiver for more than one second. At this point, the
receiver/transmitter will start the linking operation.
   
the servos will now operate by your transmitter. Please refer to the table below for the LED status of the

No signal reception Red: On
Receiving signals Green: On
Receiving signals, but ID is unmatched Green: Blink
Unrecoverable failure (EEPROM, etc.) Red and Green turn on alternately
13


Need help? Post your question in this forum.

Forumrules
1

Forum

futaba-t6j---2.4ghz

Reset search

  • Sorry my bad english, did you have the manual in spanish? Submitted on 6-10-2021 at 05:09

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba T6J - 2.4GHz at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba T6J - 2.4GHz in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info