747917
151
Zoom out
Zoom in
Previous page
1/228
Next page
151
GO to TABLE OF CONTENTS
ELEVATOR
(RUDDER 2)
RUDDER
(ELEVATOR 2)
V-Tail
[Corresponding model type]: Airplane/glider, Tail type V-tail
This function lets you adjust for left and right rudder
angle changes at elevator and rudder operation of a
V-tail airplane.
V-tail is when 2 servos are used together to control
rudder movement as elevators. In addition to each
rudder side moving up and down together, each side
moves in opposite directions when moving as elevators.
On a V-tail, this is also known as a ruddervator, as they
can serve the same purpose.
(Rudder function)
Left and right travel adjustment at
CH1 and CH2 rudder operation
(Elevator function)
Up and down travel adjustment at
CH1 and CH2 elevator operation
● Select [V-Tail] at the model menu and call
the setup screen shown below.
● Travel adjustment
Tap to the item you want to adjust.
Adjust the rate using the "▼▼" "▼" "▲" "▲▲"
buttons.
*If the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
polarity (+ or -).
*If a large value of travel is specied, when the sticks are
moved at the same time, the controls may bind or run out
of travel. Decrease the travel until no binding occurs.
Condition group/
single mode
selection (Gr. /Sngl)
●Return to Model menu
151


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba T-16IZ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba T-16IZ in the language / languages: English as an attachment in your email.

The manual is 35,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info