747917
109
Zoom out
Zoom in
Previous page
1/228
Next page
109
GO to TABLE OF CONTENTS
Tap here and go to the
Servo 2 settings page.
(Display and settings
content is the same as
Servo 1.)
When the Alarm or
Vibrator options are
activated, the servo
connection will
display.
*This alarm and display is limited to the S.BUS
servos connected to the servo sensors.
Tapping this will
take you to the
settings screen for
the current alarm
Telemetry : Servo sensor [Current]
The SBS-01S can monitor and display the in-ight
current, operating angle, and internal temperature
of up to two S.BUS2 servos.
If you forget to connect the servo wiring during
fuselage assembly, or the servo was disconnected,
an alarm can be activated at the transmitter.
*Servo sensor must be installed in the aircraft.
Select [Servo sensor] in the Telemetry
screen and access the setup screen
shown below.
Max. and min. values
since the power
was turned ON will
display.
Sets the current on
which the alarm
operates.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
Vibrator is choices are
type1-3, and Inhibit.
An upward arrow
indicates the alarm
will sound when the
current reaches above
your set value.
A downward arrow
indicates the alarm
will sound when the
current reaches below
your set value.
Initial value: ↑ 10.0A ↓ 0.0A
Adjustment range 0.0A~10.0A
( Limit ≧ ↓ Limit)
●Return to Linkage menu
Tapping this and selecting
"Buzzer" will cause the device
to sound an alarm when
servos are not connected.
Tapping this and selecting
"Each type" will cause the
device to vibrate when servos
are not connected.
109


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba T-16IZ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba T-16IZ in the language / languages: English as an attachment in your email.

The manual is 35,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info