Do not fly in the following places:
-Near other R/C flying fields (within about 2.5miles [3km]
-Near people on the ground, or objects in the air
-Near homes, schools, hospitals, or other places where there are a lot of people
-Near high tension lines, high structures, or communication facilities
Radiowave interference and obstructions may cause a crash. A crash caused by trouble in the R/C set, or the model
itself, may cause death or property damage.
Do not fly when you are tired, sick, or intoxicated.
Fatigue, illness, or intoxication will cause a loss of concentration or normal judgment and result in operation errors and a
crash.
Extend the antenna to its full length.
If the antenna is shortened, the effective range of the radio signal
will be shorter.
Always test the R/C set before use.
Any abnormality in the R/C set, or model, may cause a crash.
Before starting the engine, check that the direction of operation of
each servo matches the operation of its control stick. If a servo does
not move in the proper direction, or operation is abnormal, do not
fly the plane.
Check that the transmitter (Tx) antenna is not loose.
If the transmitter antenna comes off during use, control will be lost
and the model will crash.
When placing the transmitter (Tx) on the ground during flight preparations, be sure that the wind cannot
knock it over.
If it is knocked over, the throttle stick may be pushed to full throttle, the engine will speed up and create a very
dangerous situation.
Do not touch the engine, motor, or FET amp (speed control) during and immediately after use.
They are hot and will cause a burn.
-5-
