747921
20
Zoom out
Zoom in
Previous page
1/174
Next page
20
<Before Use>
Connector/Plug
Connector for trainer function
When you use the trainer function, connect the
optional trainer cable between the transmitters for
teacher and student.
*You can set the trainer function on the Trainer Function
screen in the System menu.
S.BUS connector (S.I/F)
When setting an S.BUS servo and telemetry
sensor, connect them both here.
(Supply power by 3-way hub or 2-way cord.)
Earphone plug
Connecting a stereo headphone to this plug, the
speech information of telemetry can be heard.
Connector for battery charger
This is the connector for charging the NiMH
battery 7,2V/ 1,800mAH that is installed in the
transmitter. Do not use any other chargers except
the attached special charger.
① Side cover is opened.
② Side cover is stuffed
into inside.
② Side cover is stuffed
into inside.
Trainer
Connector
S.BUS (S.I/F)
Connector
Earphone
Plug
Charge
Plug
Installation and removal of the transmitter
battery
Attachment of the battery
1. Open the rear case.
2. A battery is Àxed using two bands.
3. Connect the battery connector.
4. Close the rear case completely.
Battery removal
Note: If you remove the battery while the
power is on, the data you have set will not
be saved.
1. Open the rear case.
2. Disconnect the battery connector.
3. Two bands are removed and the remove the
battery.
4. Close the rear case completely.
WARNING
Be careful not to drop the battery.
Never disconnect the battery connector from the
FX-22 transmitter after turning off the power
until the screen is completely blank and the
transmitter has shut down completely.
* Internal devices such as memories may be damaged.
* If there is any problem, the message "Backup Error" will
be shown the next time when you turn on the power of the
transmitter. Do not use the transmitter as it is. Send it to the
Futaba service center.
HT6F1800B
Battery
Connector
Band
Connector
WARNING
Do not connect any other chargers except the
special charger to this charging connector.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FX22 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FX22 in the language / languages: English as an attachment in your email.

The manual is 4,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info