30098
24
Zoom out
Zoom in
Previous page
1/36
Next page
PCM RECEIVER FP-R118GP
System checking can be performed with this lamp.
•When the receiver and servo side Nicd is connect-
ed and this LED is on, radiowaves are not being
received from the transmitter, check to be sure
the frequency is correct.
Checking
is
possible by
the lamp being on.
•When strong noise has been received, or the
radiowaves from the transmitter are intermit-
tently interrupted, this lamp will blink.
This usually is not a problem.
Remove the receiver crystal
by
pulling it in this direction.
Receiver crystal
Receiver, servo switch, and battery
connections
AEC-3
Extension cord
PCM receiver
FP R118GP
Power switch
SWH-5 (R4-SWJ)
Charging connector
NR-4J
Fig.
59
Pay careful attention to the
connector polarity.
Fig.
58
Error lamp
Crystal
Fig. 56
Antenna wire
Antenna
wire
22
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP8SSHP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP8SSHP in the language / languages: English as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info