30036
5
Zoom out
Zoom in
Previous page
1/26
Next page
BEFORE USING
• Charging the transmitter and receiver Nicd battery
*Use the special Futaba charger.
• The charging time is 15 hours.
[However when the battery was
not used for some time, charge and
discharge it 2 3 times. Otherwise,
the battery will not be charged even
after the specified charging time !
• Factory setting of transmitter modulation system
The transmitter modulation system (PCM/PPM mode) is switched by
data setting. (For the setting method, see P19.). However, it is set as
follows at the factory:
FP-T7UAP ..... PCM mode FP-T7UAF ..... PPM mode
A fully-charged transmitter battery
can be used for about 10 flights of
10 minutes each. The airborne NR-
4J Nicd battery pack can be used
for about 6 flights when 6 servos
are used.
Notes: (PBC-8B)
1) First, connect to
TX Nicad and
red lamp goes on.
2) Then, connect to RX Nicad after
connecting, L, E, D, changes
color from red to greenish red
(orange) which indicates that
both TX and RX Nicads are
being charged.
3) In case of separate charging, L,
E, D, color will be:
RX Nicad - Green
TX Nicad- Red
Receiver
Nicd battery NR-4J
Remove the charging cap
and connect the charger.
(NT-8LP inside)
Tx side
Rx side
Male
Female
Charger
LED
Power plug
FP-7UAPor FP-7UAF
• Changing the transmitter Nicd battery
pack
• Changing the RF module to change the
frequency band
Remove the battery cover.
—3—
Battery cover
1 Remove the RF module.
Pull the RF module forward
while pressing these tabs to
the inside
2 Change the Nicd battery.
2 Change the RF module.
® side contact
-Nicd battery
(Only the NT-8LP
can be used.)
*Load the battery while paying careful attention to
the direction of the contacts.
Push in the new module,
while being careful not to
bend the pins, until the tabs
at
both
sides
lock
into
place
with a "click".
*Use the special FP-TP-FM RF module for the FP-
7UAP and 7UAF. Other RF modules cannot be used.
•When the transmitter frequency band is changed,
the
receiver frequency band must be changed also.
Refer to only the necessary items of the items enclosed in
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP7UAF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP7UAF in the language / languages: English as an attachment in your email.

The manual is 1,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info