30072
9
Zoom out
Zoom in
Previous page
1/20
Next page
RECEIVER AND SERVO HANDLING INSTRUCTIONS
1. The FP-R6F receiver employs an 8 bit 1C and has been especially designed for 6 channel use. (Combined 5
channel, 6 channel use.)
2. The block connectors which connect the receiver to each servo form a single unit with the receiver.
3. Connect to the servos by verifying the block connector connection positions stamped on the receiver case. Use
the white relay connector for the ailerons. Be sure to use the 3P white connector from the switch harness for
the power supply (BATT).
XTAL ... Crystal
AUX2 ... For 6CH Tx: Snap switch
AUX1 ... For 6CH Tx: Lever type switch
For 5CH Tx: Snap switch
RUDD ... Rudder (FP-3FN doesn't have
rudder)
ELEV ...Elevator
THRO ... Throttle
AILE ... Aileron
8ATT ... Power supply
(FP-3FN doesn't
have rudder)
Fig.
3
RED
FP-R6F
WHITE
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP6FN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP6FN in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info