Manual Futaba FP4DN (page 8 of 15) (English)

29996

Zoom out

Zoom in

1/15

6. Connectors are made as shown in the above diagram. Please make certain that each connector is fully plugged

in and that the Aileron section etc., and the power supply switch harness is correctly identified.

7. After making certain that the connections are correct according to the above diagram, turn on the transmitter

switch and then put the receiver switch to ON position. At this point each Servo will stop at the Neutral

position.

8. Move each stick and Trim lever and check to see if the specific Servo is actuated correctly.

9. When each section is tested for movement, please make certain that both the Transmitting and Receiving

antennas are fully extended. If the Transmitting antenna is shortened and the Transmitter switch is left ON

for more than 5 minutes, the transistors in the Transmitter will be damaged.

10.

If the system does not operate after completely assembling the batteries, switch harness and Servos for the

receiver and the Transmitter, the problem may be due to damage during shipment. Do not attempt to open

any of the units, but return them for exchange.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP4DN in the language / languages: English as an attachment in your email.

The manual is 0,93 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Futaba FP4DN Manual

Product: