29992
5
Zoom out
Zoom in
Previous page
1/20
Next page
SPECIFICATIONS:
(All
specifications
are
subject
to change
without
prior
notice.)
TRANSMITTER
Operating system......... CH1—4, 2-stick system, CH5 snap
switch, CH6 trim lever system
Operating frequencies... 27MHz band 72MHz band
40 MHz band
Antenna output............
500mW
Modulation
system
......
AM
(amplitude
modulation)
Pulse position modulation:
1310uS neutral (Pulse spacing)
Power requirement......
9.6V 8/450mAH nickel-cadmium
battery
Current
drain...............
140mA
RECEIVER
Receiving frequencies... 27MHz band 72MHz band
40MHz band
IF amplifier frequency... 455kHz
Selectivity
..................
3kHz/-3dB
Range
........................
500m
on
the
ground,
1000m
in the air
Power requirement...... 4.8V 4/450mAH nickel-cadmium
battery
Current
drain...............
4.8V 10mA
Dimensions
...............
FP-R6F:
40
x69
x19mm
FP-R4F,
R3F:
40.2x58.5
x19mm
Weight........................
FP-R6F:
52g
FP-R4F. R3F: 46 g
SERVO (FP-S7, FP-S12, FP-S16, FP-S16L,
FP-S17, FP-S8, FP-S16G)
Control
system
............
3-wire,
+
pulse
width control
650uS~ 1900uS
Operating angle............
Rotary system one side 45° min
(including trim) FP-S7. FP-S12,
FP-S16.
FP-S17
Rotary system one side 80° min FP-S8.
FP- S16G (retractable landing gear servo)
Power requirement...... 4.8V 4/450mAH nickel-cadmium battery
(used in conjunction with receiver)
Current
drain...............
4.8V
8mA
(when
stopped)
Output torque ............
FP-S7; 3kg-cm, FP-S12: 2.8 kg-cm,
FP-S16; 2kg-cm, FP-S17: 2.6kg-cm,
FP-S8: 8 kg-cm, FP-S16G: 2.6 kg-cm.
Dimensions.................. FP-S7:
23 x 44 x 41 mm.
FP-S12: 23 x 44.5 x 42.5 mm,
FP-S16:19.5x41 5x35.5mm,
FP-S17: 20 x 39.6 x 40 mm,
FP-S8; 23x44x41 mm,
FP-S16G: 19.5 x 41.5 x 35.5 mm
Weight........................
FP-S7:
48g,
FP-S12;
52g,
FP-S16;
41g,
FP-S17; 44g. FP-S8: 50g, FP-S16G; 41g.
BATTERY CHARGER (Nickel-cadmium charger)
Input
voltage
...............
115V
(220V,
240V)
Frequency
..................
50/60Hz
Power consumption ... 2.0/3.5VA
Output
Tx.
..................
9.6V, 45mA
Output
Rx................... 4.8V, 45mA
NOTE:
Power consumption is for no load/load. Since the transformer may be burned up or the performances of the battery will deteriorate due to
an
overcurreni if the NR-4C nickel-cadmium battery is connected to the Tx output terminals, always be sure that connections are correct.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP3FN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP3FN in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info