29990
8
Zoom out
Zoom in
Previous page
1/12
Next page
Fig.
9
Be alert for noise.
If engine vibration causes metal parts to
touch, noise will be produced and the re-
ceiver and servos may operate incorrectly.
We recommend the use of noiseless parts.
When installing the switch, cut a rectangu-
lar hole somewhat larger than full stroke
of the switch and install the switch so that
it moves smoothly from ON to OFF. When
the switch is mounted inside the fuselage
and is turned ON-OFF with wire, install
the switch mount in the same manner.
Install the switch where it will not come
into direct contact with the engine oil,
dust, etc.
Even though the receiver antenna is long,
do not cut or bundle it.
Install the servo firmly. Refer to Pig. 10 at
the right.
A spare servo horn is supplied. Use it as
needed. Do not forget to install the tooth
washer when changing the horn.
•Wrap the receiver in sponge rubber. Place
the receiver in a plastic bag and wrap a
rubber band around the open end of the
bag to waterproof and dustproof the re-
ceiver.
Do
the
same
with
the
receiver bat-
tery.
Also use the rubber bands wrapped around
the receiver to hold the servo and switch
leads.
•After mounting is complete, recheck each
part, then make the transmitter antenna as
short as possible, extend the receiver an-
tenna fully, and operate the set from a dis-
tance of 22 to 33 yards (20 to 30m) for
range check. The movement of each servo
should follow the operation of each stick
of the transmitter.
6
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP3EG at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP3EG in the language / languages: English as an attachment in your email.

The manual is 1,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info