29053
66
Zoom out
Zoom in
Previous page
1/78
Next page
Sailplane Section
BUTTERFLY
TRIM
Mix
(BYE)-4-S/5-S
Butterfly
trim
mixing
uses
elevator
motion
to
correct any change in model attitude when butter-
fly is activated. The CH6 volume up side and down
side correction rates can be set independently.
The correction neutral position can be offset
to
a point different from the butterfly neutral posi-
tion, but it should be matched to the butterfly
mixing offset point. Butterfly trim mixing can be
turned on and off during flight by setting a switch.
5-S
4-S
Setting Up Butterfly Trim Mixing
Activation of command
In the Condition Menu, press the
BYE
key to get the
BFY TO ELE menu as shown below.
Mode setting
Offset Setting
Correction
Rate
Setting
To On/Off Switch
Setting Menu
Return To
Condition Menu
Mode Selection Keys
Mode Setting
Use the A key to activate mode setting, then
press the
ACT
or
INH
keys ( F and G) to activate
or inhibit butterfly trim mixing.
Offsetting the Mixing Neutral Location
Press
the B
key.
Then
set
the
butterfly
control
to
the
desired offset position (usually where it begins working)
and press the
SFT
F key.
Down Side Correction Rate Setting
Press the C key and set the
rate with the numeric
keys
E to M . The setting range may vary from —100
to
+100%
and the initial value is +50%. If you use BFY
on
throttle as described previously, this may not do anything.
Up Side Correction Rate Setting
Press the D key and set the rate with the numeric
keys
E to M .
The setting range may vary from —100 to
+100% and the initial value is +50%.
ON/OFF Switch Setting
An ON/OFF switch is not defined initially, so the
mixing will be on all the time. To define one, display the
switch setting screen by pressing the
SWT P
key. Use
the keys to choose the switch and ON direction you want.
For a description of the switch setting method, see page
37.
Sailplane Section, Page 142
66


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9ZHP_part2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9ZHP_part2 in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info