29011
46
Zoom out
Zoom in
Previous page
1/78
Next page
Model Setting Section
REV—SERVO
REVERSING FUNCTION
This function is used to reverse the direction a
servo operates for a given command. This function
should be used AFTER any special menus are de-
fined to assure that all servos are moving the cor-
rect directions.
Direction Selection
Keys
NOR = Normal
REV = Reverse
Return to the Model Menu
Channel Selection Keys
Reversing Procedure
After defining a new model, be sure to define all
special menus (such as Flaperons, Aileron-Speed Flap
mixing. Differential, etc.). Be sure that all servos are
plugged into the proper receiver channels. Now, deter-
mine whether you need to reverse any channels by mov-
ing each stick and observing the corresponding movement
in the model's controls.
In the Model Menu, press the reverse function key
(
REV
) to get the Reversing menu shown below.
Now you must choose which channels you want to
reverse. Use the Up-Arrow keys (E M) to select the
desired channels.
Once you have selected the desired channel, use the
NOR
(Q) key and the
REV
(P) key to choose the
proper direction for the servo. Repeat for each servo
needing reversal.
When done, press the
END (N)
key to return to
the Model Menu.
Model Setting Section, Page 44
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9ZHP_part1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9ZHP_part1 in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info