29011
16
Zoom out
Zoom in
Previous page
1/78
Next page
Manual Introductory Section
OPERATION WITHOUT RADIO TRAMSMISSION
If you'd like to make some small corrections to
a setup OR find out what frequency the Synthe-
sizer module is set for without radiating AND
without removing the transmitter RF module or
using the DSC cable, you can do this by turning on
the power switch while simultaneously holding the
A or R keys. This may also be used to find out
what frequency the synthesizer transmitter module
will
be using. When
you
power
up
the
system
this
way, check to be sure that the "ON AIR" display
is not on. You can now set the data or check what-
ever you need to. When you are done, you may
reset the transmitter by turning off the power
switch. The transmitter will radiate normally on
the next turn-on.
SYSTEM MONITOR LIGHTS & WARNINGS
There are two indicator lights above the power
switch on either side. The right-hand light flashes
when the transmitter is transmitting, or if a flight
condition or mixing switch is activated. The left-
hand indicator lights when the system power is on,
and blinks during automatic data transfer.
In the airplane mode, either the Snap Roll
[SNP] or the Airbrake [ABK] switches will light
the indicator lights. For helicopters, Throttle Hold
[HLD] or Inverted switches [INV] will cause
flashing.
In
sailplanes,
Butterfly
mixing
[BFY]
will
activate the light.
You should also be aware that a beep sounds
every four seconds when Condition Hold [CHD] is
operating to remind you to turn it off. For your
convenience, the left and right sliders on the sides
of the transmitters emit a beep whenever they are
set at their center positions. This feature allows
you to center them without having to take your
eyes off of the model.
CAUTION!
If you are using the Synthesized transmit-
ter module FP-TK-FSS, be sure that you
know the transmitting frequency before
switching on. If you don't know the fre-
quency, hold the A or R key down as you
switch on power. The transmitting frequency
will be displayed but radio transmission is
deactivated. Once you have determined the
frequency, secure the appropriate frequency
control device and turn on power to operate
normally.
Manual Introductory Section, Page 14
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9ZHP_part1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9ZHP_part1 in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info