29047
38
Zoom out
Zoom in
Previous page
1/78
Next page
System Section
SETTING THE FREQUENCY SYNTHESIZER RECEIVER
The following procedure should be followed in
order to change the receiving frequency on a syn-
thesized receiver.
First, turn off receiver power. Next, open the
receiver's dust cover by sliding in the direction
shown by the arrow in the figure. Set the channel
number by moving the two rotary switches to the
desired frequency numbers. For example, to set
channel 20, set the left switch to 2 and the right
switch to 0. When setting is complete, close the
dust cover.
When the receiver is turned on, the frequency
set by the rotary switches is used by the receiver.
If the switch is changed during operation, the
changes will be ignored until the receiver is power-
ed down and later turned on, at which time the
new frequency will be used.
Fifty frequencies, from Channel 11 to 60
(72.010 to 72.990 MHz) can be set. If a channel
outside this range is set, the receiver will default to
Channel 11.
Frequency Synthesizer Receiver
FP-R309DPS
Dust Cover
Dust Cover
Sliding Direction
First Digit Second Digit
of Channel of Channel
Setting No. Setting No.
Channel No. Setting Switches
System Section, Page 36
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9ZAP_part1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9ZAP_part1 in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info