29041
106
Zoom out
Zoom in
Previous page
1/109
Next page
Ni-Cd: Nickel Cadmium rechargeable battery. Typically used to power transmitter and receiver. See Battery care
and charging.
NiMH: Nickel Metal Hydride rechargeable battery. Newer battery technology than Ni-Cd. Longer run times but more specific
peak charging requirements. [Require a (zero) delta peak charger labeled specifically for use with NiMH batteries.]
NORMAL: trainer mode that does not give student radio the computer programming features of the master radio. See Trainer.
NT8S: standard transmitter battery pack. See Accessories.
NULL: not assigned or never changed. Ex: a mix which has a null switch assignment is always active, and can never be
changed in flight (turned off) no matter which switch is moved.
OFFSET: (HELI) separate trim settings available to each idle-up (using CONDITION) setting, or assigned to separate
switches from the condition switches. When offset is ON, movement of the trim levers adjusts the OFFSET, not the
normal condition's trims. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .91
Offset mix: mix that independently moves the slave servo a set percentage of its total throw, not in relation to any
master. See Programmable mix.
PA2: Pilot Assist. Optional onboard device that uses optical sensors to correct modelís orientation to upright.
PARAMETER submenu: sets specific parameters. Includes reset, type, modulation, second aileron servo setup, and ATL. . . .28
PCM: Pulse Code Modulation. An electronically encoded method of transmitting data to a receiver to help minimize the effects
of interference. (Transmission is on an FM wavelength, and uses FM crystals, module and trainer cord.). See Modulation.
Peak Charger: charger that automatically stops charging when the battery is fully charged (commonly called ìpeakedî).
See Battery care and charging.
Piezo gyro: gyro that uses a piezo crystal to sense angular changes. See Gyros and Governors.
Pitch-to-rudder mix: see REVO.
PITCH CURVE: (HELI) curve that sets the response of the collective pitch servo(s) to movement of the throttle/collective
STICK. Independently adjustable in the normal flight mode, one for each of the 3 idle-ups, and one for throttle hold.
Adjusted to provide ideal blade response for various types of maneuvers being performed. For simplicity, the normal
condition's curve may be set in the BASIC menu. All 5 curves are also adjustable in the ADVANCE menu. . . . . . . . . . . 89
PPM: Pulse Position Modulation. Also known as FM. Type of signal transmission. See Modulation.
Programmable mix: used to cause specific servo responses to specific inputs separate from the basic control setups.
Includes extensive definitions of types and examples. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60
Range check or test: to test the transmitterís control over the model at a specific distance as a precaution in checking its
proper operation prior to flight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Rate: amount of control given. Ex: see Programmable mix.
RESET: to delete all data in the existing model only. User CANNOT erase all data in the radio. Only service center can
do so. Part of PARAMETER submenu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28
Retractable landing gear: landing gear that is brought up into the model during flight. . . . . . . . . . . . . . . . . . . . . . . . .66
REVERSE: servo reversing. Used to reverse the direction of a servo to ease installation and set up. . . . . . . . . . . . . . . . .31
Rudder-to-aileron mix: (ACRO / GLID) used to counteract undesirable roll (roll coupling) that happens with rudder input,
especially in knife-edge. Gives proper aileron input to counteract roll coupling when rudder is applied. Not a
preprogrammed mix. See Programmable mix. This is the default programming for one linear and one curve mix in
ACRO and GLID.
Rudder-to-elevator mix: used to counteract undesirable pitch (pitch coupling) with rudder input, especially in knife edge flight.
Not a preprogrammed mix. See Programmable mix. This is the default programming for one curve mix in ACRO.
106
OFFSET 1/2/3 (GLID2FL-C): additional flight conditions available speciffically for sailplanes . . . . . . . . . . . . . . . . . . . 75
106


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9CHPsuper at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9CHPsuper in the language / languages: English as an attachment in your email.

The manual is 8,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info