29041

Futaba 9CHPsuper Manual

38
Zoom out
Zoom in
Previous page
1/109
Next page
TIMER submenu (stopwatch functions): controls three electronic clocks used to keep track of time remaining in a competition time
allowed, flying time on a tank of fuel, amount of time on a battery, etc.
Adjustability:
•
Count down timer: starts from the chosen time, displays time remaining. If the time is exceeded, it continues to count
below 0.
•
Count up timer: starts at 0 and displays the elapsed time up to 99 minutes 59 seconds.
•
Model timer: cumulates ON time up to 99 hours 59 minites each model.
Once Model timer function is turned off, the cumulate time will also be reset to "0:00".
•
Independent to each model, and automatically updates with model change.
•
In either TIMER mode, the timer beeps once each minute. During the last twenty seconds, there's a beep each two seconds.
During the last ten seconds, there's a beep each second. A long tone is emitted when the time selected is reached.
(UP/DOWN TIMER)
•
To Reset, choose the desired timer with the SELECT key (while at the startup screen), then press and hold DIAL for 1 second.
•
Activation by either direction of SWITCH A-H, by THROTTLE STICK (STK-THR ) (Using the THROTTLE STICK is convenient if you
are keeping track of fuel remaining, or for an electric, how much battery is left); or by the power SWITCH (PWRSW).
GOAL of EXAMPLE: STEPS: INPUTS:
38
Set timer 2 to count down 4-1/2
minutes, being controlled by
T
HROTTLE STICK position. This is
utilized to keep track of actual
Throttle on time to better correlate
with fuel/battery usage.
Where next?
Open BASIC menu, then
open TIMER function.
Go to TIMER<2> .
Adjust time to 4 min. 30 sec., count down.
Assign to T
HROTTLE STICK and set
trigger point (if timer is to trigger
BELOW this throttle point, so
arrow points down).
Close.
for 1 second.
(If ADVANCE, again.)
to page 2.
to TIMER.
to 4. to 30.
to SW. to STK THR .
to POSI.
T
HROTTLE STICK to desired
position (Ex: 1/4 stick).
for 1 second to set.
Adjust END POINTs after first flight test: see p. 32.
Adjust auxiliary channel assignments (ex: move flaps to a switch): see p. 39.
Set up TRAINERfunctions: see p. 40.
… 38 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9CHPsuper at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9CHPsuper in the language / languages: English as an attachment in your email.

The manual is 8,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info