29009

Futaba 9CHFsuper Manual

90
Zoom out
Zoom in
Previous page
1/109
Next page
Revo. mixing rates are 5-point curves. For a clockwise-turning rotor, the rudder is mixed in the clockwise direction
when collective pitch is increased; for counterclockwise-turning, the opposite. Change the operating direction setting
by changing the signs of the numbers in the curve from plus (+) to minus (-) and vice versa. Suggested defaults:
Clockwise rotation: -20, -10, 0, +10, +20% from low throttle to high.
Counterclockwise rotation: +20, +10, 0, -10, -20% from low throttle to high.
Adjust to the actual values that work best for your model.
Revo. curves for idle-ups are often v-shaped to provide proper rudder input with negative pitch and increased throttle
during inverted flight. (Rudder is needed to counter the reaction whenever there is increased torque. In inverted flight,
throttle stick below half has increased throttle and negative pitch, therefore increasing torque and rotating the
helicopter unless the revo. mix is also increasing appropriately.)
IDLE-UPS: additional flight conditions available specifically for helicopters. These additional flight conditions contain
different throttle curves, collective pitch curves, revo. mixing, and trims (except IDLE-3) to make the helicopter perform
certain maneuvers more easily. Lastly, the gyro and dual rate functions may be set to provide separate rates per condition
selected, including one for each idle-up.
One of the most common flight conditions can easily flip from upright to inverted and back. To do so, the pitch curve is
set to 0 pitch at half stick, positive pitch (climb upright) above half, and negative pitch (climb when inverted) below half
stick. The throttle curve is adjusted to allow the engine to run consistently throughout the changes in pitch.
Additional idle-ups may be used to maximize the helicopterís flight characteristics in certain types of flight (i.e. fast
forward motion, backward) or maneuvers (loops, rolls, stall turns), or even the same maneuver but changing from heading-
hold/AVCS gyro mode to normal gyro mode. The 9C super provides 3 idle-ups to allow the modeler 3 additional setups
along with the normal flight condition. (Note that IDL3 does not include governor settings.)
Adjustability:
Activated with the throttle curve for that condition in THR-CURVE.
Curves are adjusted to maintain constant RPM even when the collective pitch is negative (inverted).
Note that REVO. mixing has one curve for idle-ups 1 and 2 and a second curve just for idle-up3.
Gyro settings may be set separately for each idle-up. (See p. 95.)
Governor settings may be set up to follow Normal/Idle1/Idle2, but do not offer a setting to adjust for each of the 5
conditions like gyro. (See p. 95.)
Activating OFFSETmakes the T
RIM LEVERS adjust the trim separately in each of the idle-up conditions.
For an example of throttle and pitch curves and revo, please see Normal Flight Condition Setup, p. 86.
90
•
•
•
•
•
•
•
SWITCH G (9CA) or E (9CH) is programmed for normal (NORM), idle-up 1 (IDL1),
and idle-up 2 (IDL2) curves.
Adjustable in the SW SELECT (IDL1/2, IDLE3 items).
(IDL1/2 3-position type switch only, IDL3 2-position type switch only)
… 90 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9CHFsuper at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9CHFsuper in the language / languages: English as an attachment in your email.

The manual is 8,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info