GOAL of EXAMPLE: STEPS: INPUTS:
Other Examples:
• RUD-THR (HELI) mix: When right rudder is applied, additional torque is needed from the motor to drive the tail left. Left
rudder requires less torque. A rudder-throttle mix, positive on the left side and negative on the right, adjusts for this.
• RUD-ELEV (ACRO/GLID) mix: Compensate for pitching up or down when rudder is applied.
• AIL-RUD mix: Coordinate turns by applying rudder automatically with aileron input. All model types.
• ELEV-PIT (HELI) mix: compensate for the loss of lift of tilting the model.
62
Set up a FLAP-ELEV mix:
ON when SWITCH C is in the
down position.
No elevator movement when flaps
move up (spoilers),
5% elevator movement when flaps
move down,
LINK should be ON if model has twin
elevator servos. Otherwise, LINK
remains OFF.
(Flap has no trim lever, so
TRIM
is not
an option.)
Where next?
Open an unused programmable mix.
(Ex: use PROG.MIX3 since it is already
set-up for FLAP-ELEVATOR.)
Activate the function.
Choose master and slave channels.
(Ex: no need to change MAS/SLV.)
Optional: set Master as OFST or
VR(A-E). See above for details.
Set LINK and TRIM as needed.
(Ex: leave LINK OFF, TRIM not
available.)
Assign S
WITCH and position.
(Ex: change from G to C, DOWN.)
Optional: set switch to STk-THR to
activate mix with T
HROTTLE STICK.
(See above for details.)
Optional: set switch position to NULL.
Makes mix active at all times. Not
compatible with STk-THR.
Set rates. (Ex: Lo=0%, Hi=5%.)
Set OFFSET, if needed. (Ex: 0.)
Close menu.
for 1 second.
(If basic, again.)
to PROG.MIX3.
already FLAP
already ELEV
to desired choice.
(If TRIM is available, .)
to C.
to DOWN.
to STk-THR.
T
HROTTLE STICK
to desired point.
for 1 second to set.
to NULL.
VR(A) past center. Leave at 0%.
VR(A) past center. to 5%.
Leave at 0%.
Adjust servo END POINTs: see p. 32.
Setup dual/triple rates and exponential (D/R,EXP): see p. 35.
Set up additional programmable mixes, ex: RUDDER-AILERON: see p. 60.
View numerous additional mix setups: www.futaba-rc.com\faq\faq-9c.html.
