Manual Futaba 6XH (page 29 of 64) (English)

28993

Zoom out

Zoom in

1/64

2. Control throws Fly the model and apply full

deflection of each control in

turn

Check the response of each control

• Aileron high-rate: 3 rolls in 4 seconds;

low-rate: 3 rolls/6 sec

• Elevator high-rate: to give a smooth

square corner; low-rate gives approx.

130 ft diameter loop

• Rudder: high-rate 30-35° for stall

turns; low rate maintains knife-edge

Change ATV (for high rates),

and Dual Rate settings (for

low rates) to achieve desired

responses.

3. Decalage Power off vertical dive

(crosswind if any). Release

controls when model vertical

(elevator trim must be neutral)

A. Model continues straight down

B. Model starts to pull out (nose up)?

C. Model starts to tuck in (nose down)?

A. No adjustment

B. Reduce incidence

C. Increase incidence

4. Center of

Gravity

Method 1: Roll into near

vertically-banked turn.

Method 2: Roll model inverted

A1. Nose drops

B1. Tail drops

A2. Lots of forward stick (down

elevator) required to maintain level

flight

B2. No forward stick (down elevator)

required to maintain level flight, or

model climbs

A. Add weight to tail

B. Add weight to nose

5. Tip weight

(coarse

adjustment)

Fly model straight & level

upright. Check aileron trim

maintains level wings. Roll

model inverted, wings level.

Release aileron stick.

A. Model does not drop a wing.

B. Left wing drops.

C. Right wing drops.

A. No adjustment

B. Add weight to right tip.

C. Add weight to left tip.

6. Side Thrust &

Warped Wing

Fly model away from you into

any wind. Pull it into a

vertical climb, watch for

deviations as it slows down.

A. Model continues straight up.

B. Model veers left

C. Model veers right

D. Model rolls right

A. No adjustment

B. Add right thrust

C. Reduce right thrust

D. Put trim tab under left

wing tip *

7. Up/Down

Thrust

Fly the model on normal path

into any wind, parallel to strip,

at a distance of around 100

meters from you (elevator trim

should be neutral as per Test

3). Pull it into a vertical climb

& neutralize elevator

A. Model continues straight up

B. Model pitches up (goes toward top of

model)

C. Model pitches down (goes toward

bottom of model)

A. No adjustment

B. Add down thrust

C. Reduce down thrust

8. Tip weight

(fine adjustment)

Method 1: fly the model as per

Test 6 and pull into a

reasonably small diameter

loop (one loop only)

Method 2: fly the model as per

Test 6 and then push into an

outside loop (one only, fairly

tight)

A. Model comes out with wings level

B. Model comes out right wing low

C. Model comes out left wing low

A. No adjustment necessary

B. Add weight to left tip

C. Add weight to right tip

9. Aileron

differential

Method 1: fly model toward

you & pull into a vertical

climb before it reaches

you. Neutralize controls,

then half-roll the model.

Method 2: fly model on

normal pass and do three or

more rolls

Method 3: fly the model

straight and level and

gently rock the aileron

stick back and forth

A. No heading changes

B. Heading change opposite to roll

command (i.e. heading veers left

after right roll)

C. Heading change in direction of roll

command

A. Roll axis on model centerline

B. Roll axis off to same side of model

as roll command (i.e. right roll, roll

axis off right wing tip)

C. Roll axis off to opposite side of

model as roll command

A. Model flies straight ahead without

yawing

B. Model yaws away from roll

command (i.e. right roll, yaw left)

C. Model yaws towards roll command

(i.e. right roll, yaw right)

A. Differential settings OK

B. Increase differential

C. Decrease differential

A. Differential settings OK

B. Increase differential

C. Decrease differential

A. Differential settings OK

B. Increase differential

C. Decrease differential

– 24 –

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 6XH in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Futaba 6XH

Futaba 6XH User Manual - Spanish - 55 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Futaba 6XH Manual

Product: