28993
13
Zoom out
Zoom in
Previous page
1/64
Next page
RADIO INSTALLATION
While you are installing the battery, receiver, and servos into your model’s fuselage, please
pay attention to the following guidelines:
Servo Notes
Mounting
Use the supplied rubber grommets when you mount each servo.
Be sure not to overtighten the screws. If any portion of the servo case
directly contacts the fuselage or the servo rails, the rubber grommets will not attenuate
vibration, which can cause mechanical wear and servo failure.
Servo Throw
Once you have installed the servos, operate each one over
its full travel and check that the pushrod and output arms do
not bind or collide with each other, even at extreme trim
settings. Check to see that each control linkage does not require undue force to move (if
you hear a servo buzzing when there is no transmitter control motion, most likely there is too
much friction in the control or pushrod). Even though the servo will tolerate loads like this,
they will drain the battery pack much more rapidly.
Switch Harness Installation
When you are ready to install the switch harness, remove the switch cover and use it as a
template to cut screw holes and a rectangular hole slightly larger than the full stroke of the
switch. Choose a switch location on the opposite side of the fuselage from the engine
exhaust, and choose a location where it can’t be inadvertently turned on or off during
handling or storage. Install the switch so that it moves without restriction and “snaps” from
ON to OFF and vice versa.
Receiver Notes
Antenna
DO NOT cut or coil the receiver antenna wire. It is normal for the
receiver antenna to be longer than the fuselage.
DO NOT cut it or fold it back on itself – cutting or folding changes
the electrical length of the antenna and may reduce range. Secure the antenna to the top of
– 8 –
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 6XH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 6XH in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Futaba 6XH

Futaba 6XH User Manual - Spanish - 55 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info