28989
53
Zoom out
Zoom in
Previous page
1/64
Next page
to reverse channels as necessary to get proper
throw directions.
5. Servo Neutrals
First, set up all linkages so that all servos
are as close to mechanical neutral as possible.
Then, use the Subtrim (
STRM
) window to
make fine adjustments on the servo neutrals.
6. Servo Travel
Use the
ATV
command to limit servo
travels to prevent binding.
Pitch: the pitch angle (CH6) should vary
from -2° to +10° with full stick motion.
Adjust servo arms and ATV values to get this
motion, measured with a pitch meter. If you
need to change it on the ground while the
engine is running, use the convenient
P-AT
function.
After you’ve set the pitch, be sure to check
that both aileron and elevator motions do not
cause binding at extreme pitch settings. If
they do, use
ATV
to reduce travels. Check for
binding on full left and right rudder as well.
Set up the carburetor pushrod with trim
centered or above center so that at full throttle
there is no binding, and so the engine idles
smoothly at low throttle. Be sure that trim
may be used to fully close the carburetor, to
shut off the engine without binding.
7. Hovering Pitch
We recommend setting the hovering pitch
to +4.5° by moving the hovering pitch knob
(CH6). If it takes a lot of knob travel, reset
the the knob to center, then adjust your
linkages to get the 4.5°. Then check to see
that pitch travel is still correct at high and low
stick, and correct with ATV as needed.
8. Hovering Throttle
Hovering throttle should adjusted to get
the desired head RPM around hover.
– 48 –
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 6XA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 6XA in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Futaba 6XA

Futaba 6XA User Manual - Spanish - 55 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info