28989

Futaba 6XA Manual

30
Zoom out
Zoom in
Previous page
1/64
Next page
10. Dihedral Method 1: Fly the model on
normal pass and roll into
knife-edge flight; maintain
flight with top rudder (do this
test in both left & right knife-
edge flight)
Method 2: Apply rudder in
level flight
A. Model has no tendency to roll
B. Model rolls in direction of applied
rudder
C. Model rolls in opposite direction in
both tests
A. Dihedral OK
B1. Reduce dihedral
B2. Use mixer to produce
aileron opposing rudder
travel (start with 10%)
C1. Increase dihedral
C2. Mix ailerons with rudder
direction 10%
11. Elevator
alignment (for
models with
independent
elevator halves)
Fly the model as in Test 6 and
pull up into an inside loop.
Roll it inverted and repeat the
above by pushing it up into an
outside loop.
A. No rolling tendency when elevator
applied
B. Model rolls in same direction in both
tests — halves misaligned.
C. Model rolls opposite directions in
both tests. One elevator half has
more throw than the other (model
rolls to side with most throw).
A. Elevators in correct
alignment
B. Either raise one half, or
lower the other
C. Reduce throw on one side,
or increase throw on the
other.
12. Pitching in
knife-edge flight
Fly the model as in Test 10 A. There is no pitch up or down
B. The nose pitches up (the model
climbs laterally)
C. Nose pitches down (model dives
laterally)
A. No adjustment needed
B. Alternate cures:
1) move CG aft;
2) increase incidence;
3) droop ailerons;
4) mix down elevator with
rudder
C. Reverse ‘B’ above
*Trim tab is 3/16” x 3/4” x 4” trailing edge stock, placed just in front of aileron on bottom, pointed end forward.
– 25 –
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 6XA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 6XA in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Futaba 6XA

Futaba 6XA User Manual - Spanish - 55 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info