28987

Futaba 6EXHP Manual

16
Zoom out
Zoom in
Previous page
1/24
Next page
16
REVO Pitch-rudder mixing function
This mix adds rudder in conjunction with pitch. This helps compensate for rotation of the helicopter caused by the increased
engine torque. (Never use revo. mixing with a heading-hold/AVCS gyro which is in heading hold/AVCS mode. However, revo.
mixing is still used when a heading-hold/AVCS gyro is in normal mode.)
To set the REVO mixing:
1. Enter the programming mode and use the MODE key to access the
“REVO” function.
2. Push the DATA INPUT lever upward. This will cause the flashing “INH” display to change to
a flashing
“ON” display. Now the “REVO” function is on.
3. Push the SELECT key once. This will cause the flashing “%” symbol on the display. It can
be set mixing amount on throttle stick hi side and low side separately. When you move the
throttle stick to the low side from neutral, the arrow indicates down direction and than push
up or down DATA INPUT lever to set the mixing amount of the low side. When you move the
throttle stick to the high side from neutral, the arrow indicates up direction and than push up
or down DATA INPUT lever to set the mixing amount of the low side.


GYRO Gyro mixing function
GYROS : Using electronics to take some of the complexity out of setups and flight.
What is a gyro? A gyroscope is an electronic unit that senses motion and
corrects for it. For example, if the wind blows your helicopters tail to the left, a
gyro will sense that motion (and confirm that no input was given) and will correct
for it.
How does it help in helicopter setup? A good gyro will totally eliminate the need
for revo. mixing. The gyro will sense and correct the unwanted motion for you, so
you don’ t have to spend time to get a complex curve operating properly.
Gyro sensor kinds: There are many different kinds of gyros. Early gyros were mechanical, with a spinning drum similar to a
child’s gyroscope toy. The next generation utilized a special type of crystal, called piezoelectric, which sensed the motion and
provided an electrical pulse. The finest gyros at the time of this writing are SMM technology. These silicone micro machines,
or computer chips, sense the motion. SMM is far more accurate and less susceptible to inaccuracies caused by temperature
changes, etc.
Choosing the right gyro for your skills, your helicopter, and your budget:
• Mechanical: some are still available. They are very challenging to set up and not as reliable as piezo or SMM.
• Non-Heading-Hold Piezo: these are now inexpensive gyros that are reliable and easy to set up. Some have dual rates and
remote gain control to adjust sensitivity in flight. Lack heading-hold capabilities for precision flying.
• Heading-Hold Piezo: Until recently, the cream of the crop. Expensive, and more complex to set up. Adds GPS-like heading
recognition. Exhibits minor difficulties with temperature drift (position setting varying with unit’s temperature).
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 6EXHP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 6EXHP in the language / languages: English as an attachment in your email.

The manual is 3,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info