747936
72
Zoom out
Zoom in
Previous page
1/163
Next page
Engine cut
On
Engine cut
O
ff
If the power switch is turned on while the preset
(engine cut) switch is on, an audible alarm will be
heard. Immediately set the preset switch to OFF.
72
Function
When the trigger ratio (p.66) was set to 100:0, the brake function does not operate. The
preset position set here becomes the linkage standard. The linkage is set so that the car
-
buretor is fully closed and the engine is stopped within the preset adjustment range. The
full throttle position is set by
"
Forward
"
of the end point function. The idling position is
adjusted by throttle trim.
When trigger ratio was set to 100:0
Engine Cut
When engine cut is active,
ON is displayed.
(Preparation)
- This is a switch select function. The engine cut function switch
must be set. (p.99)
- The engine cut is turned on with the assigned switch.
1
(Preset position setup)
Use the (+) and (-) buttons to set the preset position of the
throttle servo.
"B100" ~ "B1" :Brake side
"0" :Neutral
"F1" ~ "F100" :Forward side
Engine Cut function adjustment
2
When finished with setting, return to the menu screen by pressing the (END) button.
Warning display
The throttle servo operating position (preset position) set by this setting is unrelated to
the setting of other functions. Maximum to minimum servo travel can be set. However,
the reverse function setting is enabled.
Caution
Always operate carefully before using this function.
While push switch PS1~PS5, or trigger switch TS with preset function set is in the ON state, the servo (motor controller) is
locked in the preset position and does not operate even if the throttle trigger is operated. If the servo was operated at the
wrong setting, you may lose control of the car (boat).
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Preset rate
0 ~ 100
Initial value: 0%
Engine cut up ON/OFF is dis-
played by pop-up window in
the home screen.
72


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 4PX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 4PX in the language / languages: English as an attachment in your email.

The manual is 10,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info