740410
5
Zoom out
Zoom in
Previous page
1/6
Next page
Network Configuration
Setting the Stereo as the DHCP Server
If you connected more than two network devices together
directly or using a network switch or wireless access point and
did not install a router, you should configure only one FUSION
PartyBus stereo to be a DHCP server.
1
Select > SETTINGS > NETWORK > STATIC IP > SAVE.
2
Select ADVANCED > DHCP SERVER > DHCP ENABLED >
SAVE.
Configuring the Stereo for use with a Garmin
®
Marine
Network
You can connect this stereo to a Garmin Marine Network in
order to view and control the stereo using a compatible Garmin
chartplotter.
NOTE: When you configure the stereo for use with a Garmin
Marine Network, you are limited to using only Garmin and
FUSION devices. You cannot use third-party routers, phones,
storage devices, or other network products with this stereo.
Select > SETTINGS > NETWORK > GARMIN MARINE
NETWORK.
Resetting Network Settings
You can reset all network settings for this stereo to the factory
default values.
Select > SETTINGS > NETWORK > RESET > YES.
Advanced Network Configuration
You can perform advanced networking tasks on a FUSION
PartyBus device, such as defining DHCP ranges and setting
static IP addresses. See the owner's manual for more
information.
Network Troubleshooting
If you cannot see or connect to FUSION PartyBus devices on
the network, check the following:
Verify that only one device, either a stereo or a router, is
configured as a DHCP server.
Verify that all FUSION PartyBus devices, network switches,
routers, and wireless access points are connected to the
network and turned on.
Verify that wireless FUSION PartyBus devices are connected
to a wireless router or wireless access point on the network.
NOTE: Wired connections are more reliable than wireless
connections. If possible, you should connect devices to the
network using an Ethernet cable.
You may experience wireless interference if there are many
nearby wireless access points. Change the channel on your
router or wireless access point to test for and correct
interference.
Connecting a Bluetooth
®
device to a stereo configured as a
wireless access point or client may reduce wireless
performance. Disconnect Bluetooth devices to test for and
correct interference.
If you configured static IP addresses, verify that every device
has a unique IP address, that the first three sets of numbers
in the IP addresses match, and that the subnet masks on
every device are identical.
If you have made configuration changes that might be
causing networking issues, reset all network settings to the
factory default values.
Stereo Information
Specifications
Weight 475 g (16.75 oz.)
Water rating IEC 60529 IPX2
1
Operating temperature range From 0 to 50°C (from 32 to 122°F)
Storage temperature range From -20 to 70°C (from -4 to 158°F)
Input voltage From 10.8 to 16 Vdc
Current (max.) 15 A
Current (muted) Less than 700 mA
Current (off) Less than 100 mA
Fuse 15 A mini blade-type
NMEA 2000 LEN @ 9 Vdc 1 (50 mA)
Bluetooth wireless range Up to 10 m (30 ft.)
ANT
®
wireless range Up to 3 m (10 ft.)
Wireless frequencies/protocols Bluetooth 2.4 GHz @ 12 dBm nominal
ANT 2.4 GHz @ 7 dBm nominal
Compass-safe distance 15 cm (6 in.)
On-board, Class D amplifier
Output music power per
channel
4 x 70 W max. 2 ohm
Total output peak power 280 W max.
Output power per channel 4 x 43 W RMS at 14.4 Vdc input, 2 ohm,
10% THD
2
4 x 26 W RMS at 14.4 Vdc input, 4 ohm,
10% THD
2
Line output level (max.) 5.5 V (peak to peak)
Aux input level (typical) 1 V RMS
Stereo Dimension Drawings
Side Dimensions
107 mm (4.21 in.)
55 mm (2.17 in.)
130 mm (5.10 in.)
Top Dimensions
1
Vertically dripping water shall have no harmful effect when the enclosure is tilted
at an angle of 15° from its normal position.
2
The stereo may limit the output power to prevent the amplifier from overheating,
and to maintain the audio dynamics.
Apollo MS-WB670 Installation Instructions 5
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fusion Apollo MS-WB670 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fusion Apollo MS-WB670 in the language / languages: English as an attachment in your email.

The manual is 1,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fusion Apollo MS-WB670

Fusion Apollo MS-WB670 User Manual - English - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info