522212
59
Zoom out
Zoom in
Previous page
1/94
Next page
4. INSTALLATION
4-7
2) For the power cable, unfasten the clamping gland and remove washers and
gasket from the DS-605. Discard the washers and gasket. Pass the clamping
gland, washer (26-003-1607), gasket (26-003-1605) and washer (supplied as
installation materials) onto the power cable, in that order.
Note: Do not use the washers and gasket which are removed from the cable
gland of the DS-605.
3) For the sensor signal cable, unfasten the clamping gland and remove wash-
ers and gasket from the DS-605. Pass the clamping gland, washer, gasket and
washer onto the the sensor signal cable, in that order.
4) Pass each cable through assigned cable gland.
5) Put the flush mounting sponge to the flange from the rear side of the RD-50.
6) Open the front cover of the DS-605 and connect the ground wire attached in-
side the DS-605 to the ground terminal on the rear of the RD-50.
7) Connect the cables to the RD-50. Refer to section 4.5.
3. Remove each binding head screw from four corners of the DS-605 and set the
RD-50 to the DS-605.
4. Apply silicon grease to the binding head screws and fix the RD-50 to the DS-605
with four binding head screws.
5. Tighten the clamping glands to fix the cables.
6. Apply the putty to the cable glands for waterproofing.
7. Connect the ground terminal for the DS-605 to the ground terminal on the hull with
the IV-1.25 sq wire.
Power cable
Sensor signal cable
Washer*
Gasket*
*: Installation
materials
{
Clamping
gland
Washer**
Gasket**
**: Attached
inside the
cable gland
59


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno RD50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno RD50 in the language / languages: English as an attachment in your email.

The manual is 9,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info