522210
28
Zoom out
Zoom in
Previous page
1/52
Next page
3. INSTALLATION
20
How to set the cosmetic cap
Set a cosmetic cap to each fixing screw on the front panel as shown below.
3.3 Installation of Remote Controller and Dimmer
Controller
The optional remote controller RD-501 and dimmer controller RD-502 can be flush mounted in a
panel. The size and the mounting procedure are shared by RD-501 and RD-502. For the mounting
location, refer to the mounting considerations for the remote display in section 3.2.
Flush mounting
1. Make a cutout in the mounting location (88 mm (width) x 76 mm (height)).
2. Make four holes of φ4 in the location indicated in the illustration below.
3. Set the remote controller or dimmer controller to the cutout. Insert four binding head screws
(M3x12) from the front side then fasten the unit with four sets of flat washers, spring washers
and hexagonal nuts from the rear side.
Note: If it is more convenient to connect cables before you install the remote controller or dim-
mer controller, first connect the cables referring to the section 3.4.
Set cosmetic cap to hole so cap is flush with panel.
DISP
UNIT
MODE
REMOTE CONTROLLER
RD
-
501
88 ± 1.0 (3.46”)
86 ± 0.5 (3.39”)
76 ± 1.0 (2.99”)
Fixing hole (4-
φ
4)
86 ± 0.5 (3.39”)
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno RD20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno RD20 in the language / languages: English as an attachment in your email.

The manual is 4,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info