522139
44
Zoom out
Zoom in
Previous page
1/60
Next page
6-2
6.2 Installation of Antenna Unit
Mounting considerations
Install the antenna unit referring to the antenna installation diagram at the end of this manual.
When selecting a mounting location for the antenna unit, keep in mind the following points:
Do not shorten the antenna cable (10 m cable fitted to the antenna).
The length of the whip antenna for the NX-3E should be no longer than 1.2 m and no larger
than 5 mm in diameter to prevent antenna damage. Do not use a 2.5 m whip antenna. Use
spring washer (supplied) for whip antenna.
The NX-300 contains a very sensitive receiver. To avoid mutual interference with other radio
equipment, do not install this unit near an SSB/VHF/CB radiotelephone.
If the antenna cable is to be passed through a hole which is not large enough to pass the
connector, you may unfasten the connector with a needle nose pliers and 3/8-inch open-end
wrench. Refasten it as shown in Figure 6-2, after running the cable through the hole.
If you install the antenna unit except the NX-3E and the NX-3H, contact your dealer.
Center pin (soldered)
Clamp nut
Connector shell
Gasket (reddish brown)
Washer
Shield
Figure 6-2 How to assemble the connector
www.Busse-Yachtshop.de email: info@busse-yachtshop.de
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno NX-300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno NX-300 in the language / languages: English as an attachment in your email.

The manual is 1,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info