522194
26
Zoom out
Zoom in
Previous page
1/100
Next page
2. WIRING
2-4
7. Fasten a cable tie (supplied) to a cable and the “clamp leg”.
8. Connect the fan connector.
9. After you have connected all equipment, fasten the cable clamp/fan assy.
2.2.3 How to put wires into the connector blocks
The cables are connected to their connector blocks inside the Processor Unit. Open the
unit and put cables into the connector blocks as shown in the figure below.
Note: To connect two Control Units (to TB8 and TB9), change the position of the jumper
block J104 from #1-2 to #3-4. (See the illustration on page 2-2 for location.) For single
Control Unit, use TB8 and set J104 at position #1-2.
Clamp leg
Cable
Cable tie
Braided shield
(If your cable doesn't
have a braided shield,
wind the copper tape
around aluminum foil.)
Drain wire
Vinyl tape
Connector block
How to put wire into connector block
1. Remove shield of wire by 6 mm.
2. Twist core.
3. Push spring-loaded catch with slotted-head screwdriver.
4. Insert core into hole.
5. Release screwdriver.
6. Pull wire to confirm it is securely inserted.
CONNECTOR
BLOCK
Push
Twist
cores
.
Wire
6 mm
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno NavPilot 700 - Volvo Penta IPS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno NavPilot 700 - Volvo Penta IPS in the language / languages: English as an attachment in your email.

The manual is 7,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno NavPilot 700 - Volvo Penta IPS

Furuno NavPilot 700 - Volvo Penta IPS User Manual - English - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info