522217

Furuno NavNet 3D Chart Installation Guide v3.0 Manual

14
Zoom out
Zoom in
Previous page
1/21
Next page
Page 14
4. How to Install New Data onto the MFD
4.1. Introduction
When you purchase a Chart Pack, the data (charts, 3D, Sat. Photo) may be split into
multiple files that must be loaded onto multiple SD-Cards. Satellite Photos for the U.S.
are divided into specific areas, with each area fitting on one SD-Card. On the MFDBB a
USB Flash Drive can be used to load multiple areas at the same time. Make sure
however to not overload the MFDBB memory. You can simply look at the number of
Memory Slots available (Menu -> Chart Catalog) and multiply this value by two. This will
give the number of Gigabits that are available in the MFDBB to load charts (ex: if four
memory slots are available, you can load up to 8GB of data onto the Flash Drive)
When a Chart Pack is purchased, an Unlock Code will need to be entered after the
chart is copied onto the Internal Memory of the MFD.
4.2. Transfer Data to the NavNet 3D MFD
Chart Data (Charts, Satellite Photos and 3D data) must be installed on the NavNet 3D
MFD’s internal memory before it can be used by the Plotter. This process must be
repeated on every MFD in the network.
Insert the SD-Card into the upper slot of the MFD on which data is to be loaded. On the
MFDBB, you can also connect a USB Flash Drive containing the data you want to load
to a USB2.0 port (this will make the transfer much faster). Press the [MENU] key, select
the “Chart” page and then select “Data Catalog”. Press the “Install Data” button (as
seen in Figure 4.1).
Figure 4.1
Select “Yes” when the following prompt appears (as seen in Figure 4.2):
Figure 4.2
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno NavNet 3D Chart Installation Guide v3.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno NavNet 3D Chart Installation Guide v3.0 in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info