522136
33
Zoom out
Zoom in
Previous page
1/47
Next page
26
A practical choice would be somewhere
between 1/3 and 1/2 of the boat’s length
from the stern. For planing hulls, a
practical location is generally rather far
astern, so that the transducer is always in
water regardless of the planing attitude.
28
22
120
68
30
520-5PSD
24
120
68
87
520-5MSD
Unit: mm
Thru-hull mount transducer mounting
dimensions (millimeters)
Acceptable transducer mounting
locations
Position 1/2 to 1/3 of the hull
from stern.
15 to 30 cm off center line
(inside first lifting strakes.)
Within the wetted bottom area
Deadrise angle within 15°
HIGH SPEED-V HULL
Suitable transducer mounting locations
Typical thru-hull mount
transducer installations
Fairing
Block
Flat Washer
Rubber Washer
Hull
Deep-V Hull
Hull
Flat Washer
Rubber
Washer
Flat Hull
Cork
Washer
Typical thru-hull mount
transducer installations
Procedure for installing the
thru-hull mount transducer
1. With the boat hauled out of the water,
mark the location chosen for mounting
the transducer on the bottom of the hull.
2. If the hull is not level within 15° in any
direction, fairing blocks made out of teak
should be used between the transducer
and hull, both inside and outside, to
keep the transducer face parallel with
the water line. Fabricate the fairing
block as shown below and make the
entire surface as smooth as possible to
provide an undisturbed flow of water
around the transducer. The fairing block
should be smaller than the transducer
itself to provide a channel to divert
turbulent water around the sides of the
transducer rather than over its face.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno LS-6100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno LS-6100 in the language / languages: English as an attachment in your email.

The manual is 1,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info