522213
10
Zoom out
Zoom in
Previous page
1/28
Next page
2
2. WIRING
Open the IF unit with your hands, detach the shield cover and connect external equipment, refer-
ring to the illustration below and the interconnection diagram. Cables are mainly connected to the
unit with WAGO connectors. See the instructions below for how to attach wiring to the connectors.
The opener for the WAGO connectors is attached to the inside of the inner cover. Fix cables to
their respective cable posts with cable ties (supplied). Run a ground wire (IV-2.0sq., local supply)
between the ground terminal and ship's grounding bus. Supply power from breaker on mains
switchboard.
Power cable
J8 (Analog)
J7 (SC-30 Sensor)
J5 (NMEA 0183)
J4 (NMEA 0183)
J3 (AD-10)
Ground terminal
Power cable: AWG 16-20, and diameter less than 10 mm
(JIS* cable DPYC-1.5 or equivalent)
All other cables: AWG 16-28, shield, twisted, and diameter less than 8 mm
(JIS* cable TTYCS-1, TTYCS-4 or equivalent)
Cable
post
Fix cable to cable post with
two cable ties (supplied).
Cable tie
Cable post
Recommended Cables
How to wire WAGO connector
How to fix cable to cable post
1. Insert opener.
2. Press opener.
3. Insert core.
4. Release opener
.
Opener
Wire
Twist
* Japan Industry Standard cable
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno IF-NMEASC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno IF-NMEASC in the language / languages: English as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info