522155
21
Zoom out
Zoom in
Previous page
1/52
Next page
15
5. Using the two #10 x 1-1/4” self-tapping screws, temporarily screw the bracket to the hull.
DO NOT tighten the screws completely at this time. Follow the step 1-4 in “Attaching the
Sensor to the Bracket”, before proceeding with “Adjusting”.
Adjusting
1. Using a straight edge, sight the underside of the sensor relative to the underside of the
hull. The stern of the sensor should be 1-3 mm (1/16-1/8”) below the bow of the sensor
or parallel to the bottom of the hull.
11° transom angle
NO SHIM
12-18° transom angle
NO SHIM
2°-10°
transom
angle
19°-22°
transom
angle
shim with
taper up
shim with
taper down
parallelparallel parallel
slight
angle
angle
too steep
angle
reversed
YES NONO
YES YESYES
Sensor position and transom angle
Note: Do not position the bow of the sensor lower than the stern because aeration will
occur.
2. To adjust the sensor’s angle relative to the hull, use the tapered plastic shim provided. If
the bracket has been temporarily fastened to the transom, remove it. Key the shim in
place on the back of the bracket.
2°-10° transom angle (stepped transom and jet boats): Position the shim with the
tapered end down.
19°-22° transom angle (small aluminum and fiberglass boats):
Position the shim with the tapered end up.
3. If the bracket has been temporarily fastened to the transom, remove it. Apply a marine
sealant to the threads of the two #10 x 1-1/4” self tapping screws to prevent water
seeping into the transom. Screw the bracket to the hull. Do not tighten the screws
completely at this time.
4. Repeat step 1 to ensure that the angle of the sensor is correct.
Note: Do not position the sensor farther into the water than necessary to avoid
increasing drag, spray, and water noise and reducing boat speed.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno GP-7000F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno GP-7000F in the language / languages: English as an attachment in your email.

The manual is 1,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno GP-7000F

Furuno GP-7000F User Manual - English - 124 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info