522178
11
Zoom out
Zoom in
Previous page
1/45
Next page
1. INSTALLATION
5
1.4.3 Flush Mount
See the outline drawing for mounting hole dimen-
sions and fixing instructions.
1. Remove the label from over the GPS receiver's
socket. (The label may be discarded.) Apply re-
movable thread locker to the two studs sup-
plied. Screw the studs into the underside of the
GPS receiver (part A).
2. Using the gasket (part B) as a template, posi-
tion it at the selected mounting location upside
down with the arrow facing forward. Mark the
position for the two mounting holes and the
center hole for the cable.
3. Using a 3 mm or 1/8" bit, drill the pilot holes. Using a 6 mm or 1/4" bit, drill the two mounting
holes for the studs. Drill the cable hole with a 38 mm or 1-1/2" bit.
Fiberglass-Minimize surface cracking by running the drill in reverse until the gelcoat is pen-
etrated.
4. Pass the instrument connector-end of the cable through the center of the gasket and down
through the center mounting hole in the boat.
5. Plug the cable firmly into the GPS receiver.
6. Orient the gasket with the arrow facing in the same direction as the alignment tab on the GPS
receiver. Push the gasket onto the studs and slide it over the connector.
Note: The gasket fits one way only. A groove in the gasket fits over the alignment tab on the
connector.
7. With the GPS receiver alignment tab pointing forward, push the studs through the mounting
surface. Check to be sure the gasket is tucked under the lip of the unit. From underneath the
mounting surface, slide the flat washer and spring washer onto each stud. Fasten the studs
with the thumb nuts. Hand-tighten only. Do not over tighten.
8. Coat the circumference of the GPS receiver with silicone sealant so that there is no space be-
tween the GPS receiver and the mounting surface.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno GP-330B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno GP-330B in the language / languages: English as an attachment in your email.

The manual is 3,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info