551200
147
Zoom out
Zoom in
Previous page
1/187
Next page
13. INSTALLATION
13-13
8. Launch your boat and check for water leakage around the sensor.
13.4.2 Temperature sensors
Transom mount temperature sensor T-02MTB
Fix the cable at a convenient location on the transom with the cable clamp.
When the cable is led through the transom board, make a hole of approx. 17 mm in
diameter to pass the connector. After passing the cable, seal the hole with a sealing
compound.
Thru-hull mount temperature sensor T-02MSB, T-03MSB
Select a suitable mounting location considering the following points:
Select a mid boat flat position.
Select a location where the transducer will not be damaged in trailering, launching,
hauling, and storage.
Locate away from equipment which gives off heat.
Locate away from drain pipes.
Select a location where vibration is minimal.
Install the sensor as shown on the next page.
Locknut
123
Face "notch"
toward bow.
Flange nut
51
Brim
ø
77
Coat with
silicone sealant.
Unit: mm
D
5x20
D
>
50 cm
=
Flush with hull bottom.
147


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno GP-1870F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno GP-1870F in the language / languages: English as an attachment in your email.

The manual is 23,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno GP-1870F

Furuno GP-1870F Installation Guide - English - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info