689492
51
Zoom out
Zoom in
Previous page
1/75
Next page
5-1
INITIALIZATION AND ADJUSTMENT
5
.1 Opening the Installation Menus
The display unit RDP119 can be used as a sub display. If the sub display is
installed, set heading alignment, sweep timing, video signal level, antenna height
and STC slope for each display unit. Most adjustments are done on the INSTAL-
LATION SETUP menu. This menu is normally locked to prevent adjustment. Open
the menu as follows:
1. Turn off the power.
2. Turn on the power while pressing and holding down the GAIN control.
3. Press the [MENU] key to display the main menu.
4. Press the [0] key four times.
5. Press the [5] key twice to select INSTALL.
6. Press numeric keys to select item and set option.
The complete installation menus appear below.
SET UP 1
1.
2. HDG ADJ 0.0°
3. TIMING 0.044NM
4. VIDEO LEVEL AUTO MAN
5. MBS-T 000
6. MBS-L 000
7. ANT H 5m 7.5m 10m
15m 20m 30m
8. STC SLOPE SLOW MID FAS
9. ALM LEVEL LOW MID HIGH
0.
SET UP 2
1.
2. LOG RATE 0200
3. HDG SNSR GYRO MAG OFF
4. KEY BEEP OFF ON
5. HU TB OFF ON
6. VIDEO NORMAL QV
7. OS & ANT
8. BLIND SCTR
9. TUNE SET
0.
OS & ANT
1.
2. LENGTH 000m
3. WIDTH 00m
4. FORE (RDR) 000m
5. PORT (RDR) 000m
6. FORE (GPS) 000m
7. PORT (GPS) 00m
BLIND SECTOR
1.
2. FROM 180° SECTOR 000°
3. FROM 180° SECTOR 000°
OTHER
1.
2. ECHO AVG OFF ON
3. TX/ANT ROTATE STOP
4. ON TIME 000000.0H
5. TX TIME 000000.0H
6. RNG UNIT* NM KM SM
[0] key
[7] key
[0] key
[8] key
[MENU], [0] four times, [5] twice
* R-type radar only.
Figure 5-3 Installation menus
Default settings are
cir/cumscribed.
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FR1525 MARK-3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FR1525 MARK-3 in the language / languages: English as an attachment in your email.

The manual is 2,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno FR1525 MARK-3

Furuno FR1525 MARK-3 User Manual - English - 125 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info