689491
70
Zoom out
Zoom in
Previous page
1/125
Next page
-2.8-
2.5.3 Changing plot symbol mark
The plot symbol for a target may be changed after acquiring the target. This feature is available on
the R-type radar.
1. Place the cursor on the plot symbol mark you wish to change.
2. Press the [ENTER/SELECT] key successively while pressing and holding down the [HL
OFF] control to select plot symbol mark desired.
Plot symbols
Note: Changing the plot symbol mark while a target is under acquisition (target marked
with dashed square) will cause all plot symbol marks above to be shown with dashed lines.
3. To inscribe a smaller plot symbol mark, place the cursor on any plot symbol, then press the
[ENTER/SELECT] key. Mark size can be alternately selected to large or small by repeating
this step.
2.6 Terminating Tracking of Targets
When the ATA has acquired 20 targets, no more acquisition occurs unless targets are lost. Should
this happen, cancel tracking of individual targets or all targets by the procedure described below.
2.6.1 Individual targets
Place the cursor (+) on a target which you do not want to be tracked any longer by operating the
trackball and press the [CANCEL/CLEAR] key.
2.6.2 All targets
All targets can be canceled from the PLOT menu as follows.
1. Press [MENU], [7], [7] to show the PLOT menu.
2. Press the [2] key twice to select ERASE.
3. Press the [ENTER/SELECT] key.
4. Press the [MENU] key.
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FR1510 MARK-3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FR1510 MARK-3 in the language / languages: English as an attachment in your email.

The manual is 1,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno FR1510 MARK-3

Furuno FR1510 MARK-3 Installation Guide - English - 75 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info