522142
75
Zoom out
Zoom in
Previous page
1/97
Next page
8. INSTALLATION
8-2
8.1.2 Flush mount (option)
Requires the MMB-84 flush mount bracket.
1. Make a rectangular template for the flush mount measuring 65×161 mm.
2. Use the template to mark the location where the rectangular hole is to be cut. Con-
firm that the space behind the dash or panel is deep enough to accommodate the
transceiver (at least 177 mm deep). There must be at least 150 mm between the
transceiver's heatsink and any wiring, cables or structures.
3. Cut out the rectangular hole and insert the transceiver.
4. Fasten the brackets to the sides of the transceiver with the lock-washer screw
combination.
5. Turn the adjusting screws to adjust the tension so that the transceiver is tight
against the mounting surface.
8.2 Antenna
Marine antennas are made to radiate signals equally in all horizontal directions, but
not straight up. The objective of a marine antenna is to enhance the signal toward the
horizon. The degree to which this is accomplished is called the antenna's gain. It is
measured in decibels (dB) and is one of the major factors in choosing an antenna. In
terms of effective radiated power (ERP), antennas are rated on the basis of how much
gain they have over a theoretical antenna with zero gain. A 1 m, 3 dB gain antenna
represents twice as much gain over the imaginary antenna.
Typically a 1 m 3 dB gain stainless steel whip is used on a sailboat mast. The longer
2.5 m 6 dB fiberglass whip is primarily used on power boats that require the additional
gain.
Bracket
Adjusting Screw
Lock-washer screw combination
www.busse-yachtshop.de | info@busse-yachtshop.de
75


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FM-4721 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FM-4721 in the language / languages: English as an attachment in your email.

The manual is 3,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info